Skip to content
Breadcrumbs

TINS Warrant Hold Web-Based Training

Lesson 8: Releasing Holds

Learning Check

The learning check helps you ensure you understand key points of the lesson. These scores are not saved but are intended to help you decide if you need to go back and review the lesson before moving on.

At the end of the training, you will take a comprehensive exam covering key material from each of the lessons.

1. A hold record can be released (removed) from TINS when the debt has been cleared or if the record was set up in error.
2. What is the screen in TINS used to release a hold record?
3. What form is submitted by state agencies to the Comptroller’s office to authorize release of a specific warrant or warrants?
4. There are two reasons a paying agency can authorize release of a held warrant. 1. The warrant was issued from (even if partially) federal funds, or 2. the warrant was issued in error and needs to be cancelled and the paying agency has the required permission from the hold source agencies.
5. There are two TINS reports TINS6206 Held Warrant Report for Hold Source Agency and TINS6204 Held Warrant Report for Issuing Agency which allow state agencies to monitor state payments on hold — these reports should be reviewed ____.